Recent Posts

I do have some mesh, so will try that.

Many thanks for your help.

Any help appreciated.



just received and built these:-



www.fasttech.com/p/2206000
www.fasttech.com/p/2033505


KF bases and Bell caps but the airflow control screw appears to do very little, and the draw is too loose. All the Youtube videos seem to be for too tight a draw, but with these, whatever driptip I use the draw is too airy.

The airflow hole through the positive post is 2mm, and I wonder if there is a way of making it a tighter draw.

Not used these bases before, but they are pretty rough, and would not recommend them, but FT has little selection now.

Thanks in advance for any suggestions.Any help appreciated.

Been vaping for 4 years. Started on Kanthal and fairly recently graduated to 316L. Same thing with both. I NEVER burn out a coil in either material. They would last a year if I didnt get bored and just replaced them- because I think I should.
Usually, a dry burn and wash sees the coil almost as good as new (in my eyes) Maybe I am missing a vital symptom.


Would appreciate any thoughts as to when a new coil is actually needed.

Many thanks to all who replied. Such good people in this forum.

Anyway, to explain a little more.

My initial thought was that as I really need to use my existing 10amp batts (which I have quite a stock of) I would stick to fairly low res coils ~1.5ohms which to be honest, I am fairly happy with most of the time. However, as I have an Evic with TC, I would love to just try TC at my present vaping levels and see if it would improve vape quality. Maybe I am not understanding something basic, (which is likely due to advanced age) but my fear was that bearing in mind a 30watt safe vaping limit with these batts, if I used TC mode, then the mod would maybe draw more current initially than is safe, before the TC had a chance to kick in.

Once again, many thanks for any further guidance.

So from this, can I assume that it would be dangerous to use Temp Control with the 10amp Batts?

Slightly unusual I know, but my situation is that I use Kanger Subtank at present on a Vamo @ ~10watts (~1.5ohm) and get quite good Direct Lung inhales. However, the Vamo is failing, and I now have an Evic VTC Mini for which I have quite a stock of good quality 10amp batteries. I know ideally that I should buy ~30amp batteries for the Evic, but am not in a financial position to do so at the moment. My question is :- Is it possible that I can safely utilize the Temperature Control facility of the Evic using my existing 10amp batteries, or should I stay with Wattage mode?
Many Thanks for any input.

I do agree with this. Please let us know which vendor we need to avoid for the future. You never know........it may teach them a lesson about Customer Service.