moodyb
Senior Member
Joined:July 2013
Posts: 261 
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on May 8, 2014 13:28:13 GMT
Hi guys I've tried and tried to build a micro coil for my kayfun lite. I've followed super shineys method and a few other tutorials. It all goes well and looks the part until after using it for 10 mins I start getting a slight burnt taste. Any ideas?? It's sooo frustrating!! Thanks Stick your finger over the airhole & take a quick draw, say 1sec. You should notice 1 or 2 air bubbles rising up (if you're using the clear tank section ) This will pull a bit of extra liquid into the chamber & help soak the wicks. You'll know if you draw too long as it will slightly flood the chamber & you'll get gurgling. I've had to do this from day one on both my Kayfun clones - a 3.1 & Lite+. Tried all sorts to fix it with no joy - silica, ekowool, voodoowool, different amounts of cotton, different coil types, etc... |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on May 7, 2014 14:48:47 GMT
they also make vape fuses they sit on top of your battery they are only thin about 1mm i dont know where from but moodyb will hope this helps toots The fuses I used were Smok Magnet 7Amp. I bought mine originally from HealthCabin as at the time I couldn't find a vendor in the UK, but I noticed recently that UKEcigCabin have them in stock : www.ukecigcabin.com/product/smok-penny-fuseI don't think these would help toots though, as they'd make the battery even longer - 4-5mm extra length. More suitable for a telescopic mod, rather than a fixed length tube mod ( unless it has a decent sized spring in the bottom cap ) |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on May 4, 2014 8:37:46 GMT
No nemesis here either.
Tried a few bottom firing mods, but then realised I much prefered side firing ones.
|
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 26, 2014 19:43:52 GMT
looks amazing  how much they costing? 170-200 quid? Apparently it's $500  Check Vicious Ant's Facebook page & read the comments regarding it. |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 25, 2014 16:39:55 GMT
If your budget allowed £100+ then a Vaporshark DNA30 might be worth considering as it is tiny, but is also vw / regulated.
It has an internal 1200mAh battery, but at 7watts I'd imagine that would/should last a full day, unless you chain vape.
One downside, to the dna30 chip, it is that it doesn't step down the voltage.
So to get a 7 watt vape, you'd need to use a 2.4ohm coils. Your 2.0ohm coils would give 8.8watts.
|
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 25, 2014 14:14:12 GMT
These new purple Efest batteries i'm seeing about. Good, bad, ugly or just the same battery in new clothes? The 18500's have been good for me so far. Better than the old red versions and last just as long, if not slightly longer, than my AW 18490 when vaping a 1.3ohm KFL+ on a mech mod. They are a few mm longer than AW batteries though. |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 25, 2014 14:08:52 GMT
Not having to stand out in the garden smoking This. Especially when living in Scotland. |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 25, 2014 14:02:06 GMT
All sold & delivered |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 20, 2014 16:59:47 GMT
|
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 19, 2014 18:58:41 GMT
Nope. Photos aren't showing here either.
|
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 19, 2014 18:57:06 GMT
Payment received. Thanks |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 18, 2014 20:56:12 GMT
guess i need a multimeter thingy and more practise. its only a single coil and not making me cough so much Grab something like this for checking the resistance of your coil : www.vapegeek.co.uk/Ohm-meter-66.htm |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 18, 2014 20:50:31 GMT
Replied |
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 17, 2014 20:36:26 GMT
Final price drops on both.
|
|
moodyb
Senior Member
Joined:July 2013
Posts: 261
Location:
Likes: 105
Recent Posts
Last Online Sept 26, 2016 20:33:37 GMT
|
Post by moodyb on Apr 16, 2014 15:31:40 GMT
|
|
how much they costing? 170-200 quid?
