Recent Posts

It's a kir fanis trap tank with a low res boge and some red astaire

Protected batteries are usually ICR batteries with a fuse under the heat shrink wrap and the fuse cuts off to prevent a short.

ICR batteries generally have a higher mah rating but if they hard short they can vent flame turning your mod into a pipe bomb (I dont say this to scare you just to give you the relevant information, I have used ICR batteries in my mechs before but I never discharge past 3.7v since the vape tails off on my RBA's below that) These batteries are perfectly fine to be discharged down to 3.2v in a regulated mod (vamo, provari etc) or with a kick in a mech mod.

IMR batteries use a slightly different chemistry and as a result don't have as high capacity (mah) as the ICR batteries, however if these batteries hard short they vent hot gas, still gonna be hot enough to burn your hand but I'd rather have a burnt hand than a missing hand

In all fairness though it boils down to being responsible and treating a mechanical mod with the respect it deserves, you are sticking a 3.7v battery in your mouth so if you don't know what you are doing then it's an accident waiting to happen (the proverbial you not you personally)

The kick means you can use any of torchy's batteries but if you want a 1 battery type works in all mods kind of thing go for the IMR batteries, they don't last as long between charges but you can use them with or without the kick in a safer way than using ICR batteries.

Out of curiosity who makes your kayfun clone Alec? Just asking because I may have to buy one at that price, much cheaper than I've seen it elsewhere in the UK.

Also hope you didnt think I was being funny with the comment, just saves you the hassle if someone buys it thinking it's a genuine.

Swap you a rare limited edition hand carved fully stainless steel carto and the contents of my pocket for the kayfun? (the hand carved carto is amazing, it's a work of art honest! Not just a carto I bodged in my carto puncher)

www.ebay.co.uk/itm/1-LITRE-MONOPROPYLENE-GLYCOL-MPG-USP-EP-GRADE-/281050457835?pt=UK_BOI_Medical_Lab_Equipment_Lab_Supplies_ET&hash=item416fe9a6eb little bit cheaper for you guys and they sell VG too with free shipping on all items

Sometimes the pin in the bottom of the head can compress the rubber tube that holds the wires in place, this causes major airflow issues, try pulling the pin out of the head slightly and see if that makes a difference.

would you be interested in selling the KFL seperately?