Recent Posts

I have one..good machine. You can likely knock a wall down with it?

If its in the Gift section it has a ref number. When you buy an item you put that ref mum into the gift coupon box on the sales form before you pay. Like adding the discount code.

Its as link below. It came with my iStick 60W set. I use rebuildables mainly so this is redundant.

It does not have a box because its part of above set but it has all spare seals, one new atomiser and one used to test the TC function only.

www.fasttech.com/products/3006/10011884/3576300


£10 delivered and f&f paypal.

Its super heated vapour...aka steam. The coil is boiling neat juice as in a kettle and is explosive. You may notice a kettle popping loudly when it is switched on? Effect known as kettling in boilers.

The wick should be denser so that the juice doesn't puddle in the atty.

It may leak if too much juice is in the atty... the pressure difference across the tank is not negative (vacuum).

I run Ad Blockers on every site because they are a nuisance...repeat...repeat. Exactly the same as the junk/childish TV advertising. So much of it is akin to brain washing and as the too frequent repeat of the News on both TV and Radio.

I don't see any Ads at the bottom of AAEC pages. Have I blocked them as well?

Had one of these KF V3's Clones for about a month. Fiddly screws for coil connection but worked real good till leaky stuff happened...about 3 weeks. Fitted new coil (1.2K) and encountered frequent shorting/low res. Ensured no coil wire was exceeding the screw post edges. Still ad hoc shorts.

Looked at it all again and observed coil post/screws to chimney case. Appears very close....too close. Grabbed long nose pliers and squeezed top of coil posts a little. Result - no shorts/low res.

Squeezing that lot likely causes a later problem..trash can notified of future invasion?

Get what you pay for...I know!