WOW - FT Kayfun relacement base!!

[VapingBad]

Getting better flavour from this with the Ni200 Clapton Hendrix coil I posted above than a SubTank mini with 0.5 OCC head even though it cant take as much power. Not tried temp limiting on the ST yet.

[VapingBad]

They just put up a V2 for half the money www.fasttech.com/products/1/10009156/3584200-replacement-base-for-kayfun-monster-v2-rta

ETA  FAIL the air channel is a standard one so no advantage

[hijack]

Oct 10, 2015 9:05:28 GMT VapingBad said:

They just put up a V2 for half the money www.fasttech.com/products/1/10009156/3584200-replacement-base-for-kayfun-monster-v2-rta

ETA  FAIL the air channel is a standard one so no advantage

that new one looks bad all round

[VapingBad]

Yep hijack, it looks like they just drilled the 2 big holes at the bottom of a standard base, not even enlarged the juice channels a bit like these wide bore drip tips with the normal thin hole at the bottom people will still buy them.

[hijack]

Oct 10, 2015 9:27:46 GMT VapingBad said:

a bit like these wide bore drip tips with the normal thin hole at the bottom people will still buy them.

Guilty^^^^......But then I have a drill and a vice to finish what was started. 

[VapingBad]

Latest build is not wicking quite well enough so I put a vape band around it blocking the air holes on one side while vaping and if I sense it getting dry I just slip it down over the other 2 holes and suck on the drip tip to pull some liquid into the wick. It works very well and I can jut do it with the thumb of the hand I'm holding the mod in.

[letsavit]

Still liking my "normal" base with 2 air holes and deeper channels, can get a nice 20watts through a kayfun with MTL with no fancy wicking.

Got 3 replacements finally back on there way, better have the threads cut right tbis time or fastech is going get it.....!